Gewiss Chorus GW 10 798 Mode D'emploi page 23

Commands sent to the KNX/EIB bus
According to the type of RF device used, on the action performed on it and the function
set on the receiver KNX/EIB channel, the receiver will send the KNX/EIB bus a precise
command, as seen in the charts below.
IR with twilight switch RF movement detector
RF device
sensor action
IR activation
IR +
activation
twil. switch
activation
twilight
switch deactivation
(1) Channels 1 through 4 can be set as a "command sequence" while channels 5 through
8 as "8/16 bit values".
RF timed-thermostat or RF bi-directional timed-thermostat
RF device action
system ON
system OFF
GENERAL DESCRIPTION
Function configured on the receiver EIB channel
switching
ON
ON
ON
OFF
Function configured on the receiver EIB channel
23
command
dimmer sequence / 8/16
bit values
ON
ON
ON value 1
OFF value 2
switching
ON
OFF
E
N
1
G
L
-
I
-
S
H