Quick Start Guide - Xoro HTC 2228D Mode D'emploi

1. Mount the stand in order to the description on the previous page.
2. Connect the aerial or input source to the appropriate input socket at the rear of the set.
3. Switch the power on by pressing the POWER button on the front panel or the remote control. The
LED will show a green light.
4. Use the SOURCE button on the front panel or the remote control and a popup window with the
sources appears on the screen. You can select following sources: DTV, ATV, SCART, AV,
COMPONENT, DVD, VGA or HDMI. You can use the front panel control to adjust the volume or
select a channel, as shown below, or you may use the remote control and confirm by OK button.
A. Analog TV tuner (for example: cable system)
After switched on and press the SOURCE button and choose "ATV" by pressing the navi-
gation button UP/DOWN and confirm by the OK button. Now the HTC 2228D is in TV
Mode. By the first using of the TV set, the systems starts automatically the menu for
searching the TV channels (please refer page 21).
B. DVD-Player:
Switch on the unit and press the SOURCE button and choose "DVD" by pressing the navi-
gation button UP/DOWN and confirm by the OK button. Now the HTC 2228D is in DVD
Mode.
C. DVB-T mode:
Switch on the unit and press the SOURCE button and choose "DTV" by pressing the navi-
gation button UP/DOWN and confirm by the OK button. Now the HTC 2228D is in DVB-T
mode. By the first using of the TV set, the systems starts automatically the menu for
searching the TV channels (please refer page 21).
5. To switch the set off a short time, press the POWER button, the set will go into stand-by and the
LED will show red . lf you are not going to use the set for some time, switch the power off com-
pletely by unplugging the mains cable.
12

Quick start Guide

HTC 2228D