Replacing The Impeller - Kobalt 2600703A Mode D'emploi

CARE AND MAINTENANCE

3. REPLACING THE IMPELLER

• Remove the 4 sets of nuts and bolts on the
middle steel plate.
• Remove the 4 sets of nuts and bolts on each
side.
• Remove the impellers (R).
• Install the new impellers.
• Tigthen the 8 sets of nuts and bolts that you
removed.
SERVICE
Servicing requires extreme care and knowledge and should be performed only by a qualified service
technician. For service, it is suggested you return the product to your nearest AUTHORIZED SER-
VICE CENTER for repair. When servicing, use only identical replacement parts.
WARNING
If the battery pack is installed into the snow thrower, the snow thrower could start accidentally while
the operator is performing maintenance on it, which could cause serious personal injury. Remove the
battery pack before performing any maintenance.
STORAGE
• Run the snow thrower for a few minutes in order to melt any snow that may be left on the snow
thrower.
• Wipe the snow thrower off with a dry cloth before storage. This will help prevent ice building up on
the unit and parts freezing.
• Remove the battery and store it in a cool dry location, if possible. Charge the battery every six-
months when not in use in order to increase its life.
• Inspect the snow thrower thoroughly for worn, loose, or damaged parts. If any parts must be re-
paired or replaced, contact 1-866-456-8934.
• Store the snow thrower in a clean, dry place. Cover it in order to provide added protection.
• Always store battery and charger indoors.
3
4 sets of bolts and nuts
on each side (total of 8 sets)
17
4 sets of nuts and bolts on the
R
middle steel plate