Goodway REAM-A-MATIC Mode D'emploi page 6

2. Insert the two large plastic thumbscrews through slotted holes in the handle
bar and fasten loosely into the tapped holes in the middle of each side of the
machine.
3. Push the connecting bar up against the drive unit so that the dolly bar is tight
against the bottom of the drive unit.
4. Tighten the two thumbscrews, and turn the machine upright.
CONNECTING FLEXIBLE SHAFTS – ALL MODELS
1. Select the proper size flexible shaft (GTC-701, GTC-702, GTC-703, GTC-704,
GTC-720, GTC-721) for tube diameter and length to be cleaned.
Note: The heavy-duty
should be used for the RAM-4X machine [O.D. of outer casing is
and 0.955" (24.3mm) respectively].
2. Insert square end of flexible shaft into the square in the drive shaft of the
machine. The shaft may have to be turned slightly for alignment.
3. Tighten large nut securely, making sure O-Ring (P/N 805) is in place.
OPERATION
CAUTION: Do not operate the Ream-A-Matic without eye protection.
WET APPLICATION – ALL MODELS
1. Connect water hose to water inlet. Water supply should be clean
(use screen washer) to avoid clogging orifice in solenoid valve.
Consult the Goodway catalog for heavy-duty water supply hose.
2. Open water supply line. DO NOT RUN DRY. Solenoid on drive unit will allow
water to flow through the flexible shaft assembly only when the machine is
running.
3. Plug electric cord into an outlet in accordance with voltage and amperage
of the nameplate.
4. Tip the machine over on its back side so that flexible shaft is parallel to floor.
(RAM-4 and RAM-4X).
5. Remove footswitch from tool storage compartment, and position switch in
a convenient position for the operator.
4
/ " (12.7mm) diameter flexible shaft (GTC-720, 721)
1
2
/ " (19.1mm)
3
4