Changhong LED40D2080ST2 Mode D'emploi page 19

8.DVB-S2 Operation
8.1First Time Installation
Please press the source button to enter input menu and use/ direction buttons to select DVB-S2 and press OK
key to confirm. The Channel List for ASTRA is already installed. You are now ready to watch TV.
If you are using different satellites please follow the system settings instructions to set up the satellite.
If you are using more than one Satellite you need to assign the satellites the correct DiSEqC-LNB that is used
in your satellite installation.
8.2 Satellite Managment
Configure the settings of satellites.
▼/▲
Satellites' list: Press
◀ /▶
LNB Type: Press /OK to show the list of LNB Types which is shown as frequencies of local oscillator. You
also can enter frequency by User Single, User Dual at bottom of the list.
◀ /▶
LNB Power: Press
◀ /▶
22K: Press to switch on or off the 22K,which is set with auto when LNB Type is dual local oscillator.
Toneburst: Enable or Disable the toneburst switcher.
DiSEqC1.0: Select the right port up to 4 for the right LNB.
DiSEqC1.1: Select the right port up to 16 for the right LNB.
Motor: Press LEFT/RIGHT to select DiSEqC1.2 or DiSEqC1.3. Then Press OK to
show the menu to set position.
DiSEqC1.2: Move the motor to a right position to lock the signal.
DiSEqC1.3: Move the motor according to the local and satellite positions.
Motor Settings: Select DiSEqC and press OK to open.
Move Auto: Press LEFT/RIGHT to start to move West/East. It will be stopped
automatically when the signal is locked.
Move Continue: Press LEFT/RIGHT to start to move West/East. It will keep moving until you stop it.
Move Step[1]: Press LEFT/RIGHT to move just a step.
Store Position: Store current position of motor.
Goto Position: Press LEFT/RIGHT to goto the position stored.
Goto Reference: Rest all the positions.
Goto X: Goto the position calculated from the local and satellite positions.
8.2.1 Satellite settings
Add satellites:
Press RED to add a new satellite, in which you must input an unique longitude, and edit the satellite's name
with soft keyboard.
Edit satellites:
Press GREEN to edit the focused satellite.
Delete satellite:
Press YELLOW to delete the focused satellite.
Press OK to confirm.
to select a satellite, whose settings will be shown at right side.
to set the LNB power.
TV OPERATION UK
UK 18