Product View; Getting Ready - Bissell LIFT-OFF STEAM MOP 23K5 Mode D'emploi

A

Product View

Do not plug in your steam mop until you are familiar
with all instructions and operating procedures.
1 Steam on Demand Trigger
2 Steam Trigger Detachable
Pod Release
3 Easy Carrying Handle
4 Quick Release™ Cable Wrap
5 Power Cable
6 Removable Water Tank
7 Steam Control Knob
8 Detachable Steam Pod
9 Water Purification System
10 Lower Cable Wrap
B
Assembly
Assemble your Lift-Off™ Steam Mop quickly
and easily with a Phillips-head screwdriver.
Your Lift-Off Steam Mop is packaged with
the following items:
Handle Assembly
Lower Body base
Detachable Steam Pod
with water purification
Manoeuvrable Swivel Head
Removable Water Tank
1 small Phillips Head Screw taped to handle
2 Deluxe Mop Pads
1. Attach lower body base to manoeuvrable
swivel head.
2. Secure manoeuvrable swivel head
with small Phillips head screw. Tighten
until secure.
3. Slide handle assembly down into lower
body base until it will go no further. Secure
the handle by turning the knob until tight.
Lift-Off Steam Mop assembly is
now complete.
Thermal shock can shatter glass. Before cleaning
cold glass surfaces, carefully warm the surface by
directing the steam jet on the glass from a distance
at no less than four to six inches.
Never put descaling, aromatic (not including the
BISSELL Eucalyptus Mint and water products),
alcoholic or detergent product into the steam
cleaner, as this may damage it or make it unsafe for use.
11 Ready Light
12 Manoeuvrable Swivel Head
13 Deluxe Mop Pad
14 Small Screw
15 Circular detail brushes (2)
16 Grout brush
17 Flat surface cleaning tool
18 Flat surface pad (2)
19 Window squeegee
C
Operations

Getting ready

1. Attach mop pad
a. Set the mop pad flat on the floor.
b. Line up the mop head and place it
inside the mop pad with cord located
at rear of mop head. Tighten cord to
ensure tight fit.
2. Fill water tank
a. Remove tank by lifting straight up
and away from the unit.
b. Unscrew cap and remove from tank.
c. Fill water tank with water.
For best results, water should
be at room temperature.
d. Replace the assembly cap and tighten
until snug.
e. Replace water tank by lining up
vertical guides and gently sliding tank
into place.
3. Select a steam control setting. Light is for
delicate floors such as hardwood and
laminates. Normal is for everyday cleaning,
and Tough is for hard to clean messes.
4. Twist the Quick Release™ cable wrap
clockwise to unwrap the power cable
completely and plug into a 220V-240V
grounded electrical socket as described on
the Important Safety Instructions, page 3.
5. The ready light will illuminate in 30
seconds when the Lift-Off Steam Mop
is ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior to
cleaning with the Lift-Off Steam Mop.
Exercise extreme care when using the Lift-Off Steam
Mop on timber flooring. Prolonged application of
steam in one area increases the risk of damage
to the surface treatment on timber floors. Test steam mop in
an inconspicuous area before mopping a large area. The steam
mop generates hot steam, so move the unit continuously when
depressing the trigger. The trigger does not need to be depressed
at all times.
Regular foot traffic and direct sunlight will wear down timber floor
surface treatment, making it more susceptible to steam damage.
Check with your timber floor treatment and application specialist
prior to steam mop operation.
www.BISSELL.com
5