Common Hardware Problems - MAAX Spas CALIFORNIA COOPERAGE 167 Guide De L'utilisateur

NOTE: If your source water has a high metal or mineral content, a specialty chemical should
be used to avoid staining or accumulation of deposits. These guidelines cover the most
common water problems when operating a spa with ozone. Contact your dealer for further
information regarding chemical control issues.

COMMON HARDWARE PROBLEMS

Problem Usual Cause
System not - House circuit breaker tripped or in
operating
OFF position
Heater not - Water level too low - Heater mode
operating not selected - No power to heater
- Heater not operating
Water not clean - Clogged or blocked floor suction of
skimmer - Filter clogged (dirty) - Poor
water chemistry - Insufficient filtering
time - Improper maintenance
- High content of solids in water
Abnormal - Excessive evaporation and/or
water usage
splashing
Overheating
- High ambient temperature
Low water flow - Operating in FILTER mode-low speed
from jets - Clogged or blocked suction or skim-
mer - Dirty filter - Jets in OFF position
- Slice valves closed
29
CALIFORNIA COOPERAGE
Solution
- Reset circuit breaker on house
breaker panel
- Add water to reach fill line on
Weir door - Refer to temperature/
heater functioning. See Control
instructions pg. 16 - Check house
circuit breaker - Contact dealer
- Clean floor suction/skimmer. Re-
move blockage - Clean of replace
- See Maintenance section pg. 20
- Run filtration mode longer
- Contact dealer - See
Maintenance section, pg. 23 - Use
clarifier or drain and refill spa
- Use spa cover and refill as
necessary
- Contact dealer
- Select hi-speed jets - Clean floor
suction/skimmer. Remove block
age - Clean or replace - Open jets
- Contact your dealer
29