SunnyBAG 209A_10 Manuel Utilisateur page 4

Charging USB devices
This POWERPACK works to charge most of rechargeable USB devices.
1. Plug the USB cable in the POWERPACK.
2. Plug the other end of cable in the device.
3. When connected correctly, the connected device will automatically
start charging.
4. When the POWERPACK charges the connected device, LED indicators
will turn on and indicate the battery capacity.
5. When the device is fully charged, the LED indicators will keep on.
6. Then simply unplug your devices and disconnect the cable from the
power pack.
OPF – Omnidirectional Powerflow
OPF allows simultaneous and very efficient charging of your USB device through
the POWERPACK because of two separate charge controllers. One for charging
one for discharging.
AWC – Autostart Wireless Charging
The SUNNYBAG POWERPACK supports Wireless Charging. Compatible devices
can be charged wirelessly and without pressing any additional buttons. The
charging process will start automatically once the POWERPACK is moved and
detects a wireless charging smartphone.
MDS – Movement Detector Switch
In order to save energy, the POWERPACK switches to standby-mode after it has
not been moved for one minute. As soon as it will be moved again, it starts
charging automatically over the two USB ports and the wireless charger.
Wireless charging
The POWERPACK has a built-in wireless charger on top that works with most of
Wireless Charging devices.
1. Put the wireless charging devices on the white printed circles in the
middle of the POWERPACK.
2. Move the POWERPACK or press the button to turn on the wireless
charging mode.
3. Wireless charging works when wireless indicator turns to blue.
4
ENGLISH