Axis P7214 Guide D'installation page 12

Page 12
Set the password
To gain access to the product, the password for the default administrator user root must be set. This
is done in the 'Configure Root Password' dialog, which is displayed when the AXIS P7214/P7210 is
accessed for the first time.
To prevent network eavesdropping when setting the root password, this can be done via an
encrypted HTTPS connection, which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog shown
below.
To set the password via an encrypted HTTPS connection, follow these steps:
1. Click the Create self-signed certificate button.
2. Provide the requested information and click OK. The certificate is created and the password can
now be set securely. All traffic to and from the AXIS P7214/P7210 is encrypted from this point
on.
3. Enter a password and then re-enter it to confirm the spelling. Click OK. The password has now
been configured.
To configure the password directly via an
unencrypted connection, enter the password
here.
4. To log in, enter the user name "root" in the dialog as requested.
Note:
The default administrator user name root cannot be deleted.
5. Enter the password as set above, and click OK. If the password is lost, the AXIS P7214/P7210
must be reset to the factory default settings. See page 18.
6. If required, click Yes to install AMC (AXIS Media Control), which allows viewing of the video
stream in Internet Explorer. You will need administrator rights on the computer to do this.
AXIS P7214/P7210 Installation Guide
To create an HTTPS connection, start by
clicking this button.