Olympia PS 706.3 CCD Mode D'emploi page 20

5 Operation
The recommended capacities stipulated in Chapter "Technical Data" must
Note:
not be exceeded, otherwise material will jam! Do not forget that the thick-
ness of the paper increases when folded, as a result of which the recom-
mended sheet capacity can be exceeded. Also reduce the quantity of pa-
per when shredding coarse paper.
5.1 Switching the device on
1. Set the On/Off switch to its ON position.
The POWER indicator lights up green.
2. Press the AUTO button. The device is ready to operate.
5.2 AUTO function
When the AUTO function is activated, the shredding operation of the cutting mechanism
starts up automatically as soon as material is inserted in the infeed slot:
The device switches to forward drive and draws the material in.
●
When shredding is finished, the device switches off automatically.
●
The AUTO function is activated by pressing the AUTO button.
When the AUTO function is activated, paper can be shredded via the ma-
Note:
nual or automatic infeeds and CDs and credit cards shredded via the re-
spective infeed. Only one infeed may be used at a time. If you use more
than one infeed, the device stops. Pay attention to the permissible quantity
of material which can be shredded.
5.3 Inserting paper in the manual paper infeed
A maximum of 6 sheets of A4 paper with a weight of maximally 75 g/m
Note:
may be inserted in the manual paper infeed at a time.
1. The device is switched on and the AUTO function is activated.
2. Insert paper in the manual paper infeed.
5.4 Inserting paper in the automatic paper infeed
A maximum of 75 sheets of A4 paper with a weight of maximally 75 g/m
Note:
may be stacked in the paper infeed.
1. Pivot up the automatic paper infeed. An audible "click" signals that the automatic
paper infeed is in the correct position.
2. The device is switched on and the AUTO function is activated.
3. Insert the paper to be shredded in the automatic paper infeed.
20
2
2