Important - Axis M3024-LVE Guide D'installation

English
Safety information
Hazard levels
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NO TICE TICE
NO NO TICE
Indicates a situation which, if not avoided, could
result in damage to property.
Other message levels

Important

Indicates significant information which is essential
for the product to function correctly.
Note
Indicates useful information which helps in getting
the most out of the product.
Safety instructions
WARNING
IR emitted from this product. Do not stare at
operating lamp.
NO NO TICE NO TICE TICE
•
The Axis product shall be used in compliance
with local laws and regulations.
•
Store the Axis product in a dry and ventilated
environment.
•
Avoid exposing the Axis product to shocks or
heavy pressure.
•
Do not install the product on unstable poles,
brackets, surfaces or walls.
•
Use only applicable tools when installing the Axis
product. Using excessive force with power tools
could cause damage to the product.
•
Do not use chemicals, caustic agents, or aerosol
cleaners.
•
Use a clean cloth dampened with pure water for
cleaning.
•
Use only accessories that comply with the
technical specification of your product. These
can be provided by Axis or a third party. Axis
recommends using Axis power source equipment
compatible with your product.
•
Use only spare parts provided by or recommended
by Axis.
•
Do not attempt to repair the product yourself.
Contact Axis support or your Axis reseller for
service matters.
•
The power supply shall be plugged in to a socket
outlet installed near the product and shall be
easily accessible.
•
Use a limited power source (LPS) with either a
rated output power limited to ≤100 W or a rated
output current limited to ≤5 A.
Transportation
NO TICE TICE
NO NO TICE
•
When transporting the Axis product, use the
original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery
as the power supply for its internal real-time clock
(RTC). Under normal conditions this battery will last
for a minimum of five years.
Low battery power affects the operation of the RTC,
causing it to reset at every power-up. When the
battery needs replacing, a log message will appear
in the product's server report. For more information
about the server report, see the product´s web page
or contact Axis support.
Lithium coin cell 3.0 V batteries contain
1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
WARNING
•
Risk of explosion if the battery is incorrectly
replaced.
•
The battery should be replaced with an identical
battery only.
•
Used batteries should be disposed of according
to local regulations or the battery manufacturer's
instructions.
Dome cover
NO TICE TICE
NO NO TICE
•
Be careful not to scratch, damage or leave
fingerprints on the dome cover because this
could decrease image quality. If possible, keep
the protective plastic on the dome cover until
the installation is complete.
•
Do not clean a dome cover that looks clean to
the eye and never polish the surface. Excessive
cleaning could damage the surface.
•
For general cleaning of the dome cover it is
recommended to use a non-abrasive, solvent-free
neutral soap or detergent mixed with pure water
and a soft, clean cloth. Rinse well with pure
lukewarm water. Dry with a soft, clean cloth to
prevent water spotting.
•
Never use harsh detergents, gasoline, benzene,
acetone, or similar chemicals.