Bushnell TOUR V4 Mode D'emploi page 7

button again at any time to distance to a new target. As with any laser device, it is not recommended to
directly view the emissions for long periods of time with magnified lenses. The maximum time the laser is
transmitted (fired) is 10 seconds. To re-fire, press the POWER/FIRE button down again.
LIQUID CRYSTAL DISPLAY (LCD) INDICATORS
Your TOUR V4 's LCD incorporates illuminated icons or symbols that indicate the selected unit of measure,
when the laser is actively firing, when a target has been acquired, and targeting modes. A summary of
these features follows:
MODE and UNIT OF MEASURE OPTIONS
The TOUR V4 can be used to measure distances in yards or meters. The unit of measure indicators are
located in the lower right portion of the LCD. To select between yards and meters (#201660), press and
hold the POWER/FIRE button. The display will begin to cycle through the options (#201661): Yards w/
Slope, Yards, Meters w/Slope, Meters (for details on the Slope feature, see "About Tour V4-Slope Edition"). When
the units and Slope mode you want to use are displayed, release the POWER/FIRE button to select it. If
you are changing from yards to meters, a change in unit of measure will be indicated by the illumination
of the M for meter indicator while the Y for Yard indicator is turned off. If you are changing from meters
to yards, the opposite will occur. The TOUR V4 will return to the last unit of measure setting used each
time the unit is turned on.
ACTIVE LASER
Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has
been acquired, you can release the POWER/FIRE button. The crosshairs surrounding the circle will
disappear once the POWER/FIRE button has been released (i.e. the laser is no longer being transmitted).
7