EXALTA EL-214 Manuel D'instruction page 14

GB
INSTRUCTIONS FOR USE
Remove the small water tank by pressing the "release" button. Raise the
small black rubber protection and fill the tank with water, preferably
distilled. Place the tank back on the appliance making sure that it is
correctly positioned and locked. Make sure that your hands and the tank's
outer surface are perfectly dry.
If you need to refill the tank, disconnect the device from the power supply
and connect it immediately after filling the reservoir, avoiding touching
the hot plates.
Wait approximately 2-3 minutes before using the steam function.
Insert the plug into the socket and press the on-off button.
The red ionic LED lights up to indicate that the ionic function has been
activated. The green LED also lights up and flashes indicating a low
temperature setting.
Select the desired temperature (170°C - 185°C - 200°C - 215°C - 230°C) by
using the appropriate keys (+ and -). The set temperature's corresponding
LED will begin to flash indicating that the plate is heating up. The appliance
has reached the set temperature and is ready for use when the LED lights
up and stops flashing.
When the appliance is used for the first time some smoke and a particular
scent may be emitted: this is to be expected but is noticeable only during
initial use.
The appliance also emits a faint buzz. This is the characteristic noise of an
ion flow generator.
Use with steam function
Activate the steam function by using the switch. Choose the desired steam
flow depending on your hair type (normal flow-high flow).
The retractable comb allows you to evenly split the strand between
the comb's teeth and untangle your hair with ease. You can also switch
14