Albrecht BPA 300 Mode D'emploi page 10

IMPORTANT NOTES
 To connect two Bluetooth devices simultaneously to the BPA300 please repeat the
pairing process again as described above for the second unit.
 In case of BPA 200 / BPA 300 or ALBRECHT Tectalk Duro BT there is no need to
enter any PIN code. The BPA 300 is automatically detected after starting the pairing
mode.
 If the partner unit has BT V 2.1 or higher, the units may already apply the "Secure
Simple Pairing" without any need for PIN code exchange.
Starting the communication
 Both Bluetooth devices must be switched on.
 Just press the button shortly at the BPA 300 (and / or on the other device) The LED will
change to connect ready mode (mobile phone) or directly into talk mode (voice
connection)
The different Bluetooth handsfree- or headset- protocol implementations in some devices
may request to start the communication at the headset adapter by pressing 1 x shortly the
knob, or you may be able to start the communication at the other device. Just test which knob
you need to push. Both devices are connected in talk status, as soon as BPA 300 shows 3 x
green LED flashing every 3 seconds
Not all mobile phones may support all of the below described possible functions, please refer
to the operating guide for your Bluetooth mobile phone for compatibility. For motorbike use, the
best way of communication is to select "automatical call acceptance" at the mobile phone.
Only in that case you can accept incoming phone calls without pressing any knob. Please be
aware that any communication through a mobile phone can be dangerous during driving a
motorbike. If possible, stop driving and find a parking lot for making your phone calls.
Accepting incoming calls
If you have not programmed automatic call acceptance in your mobile phone, you will hear the
ring tone in the headset when there is an incoming call on your mobile phone. You can now
accept the call by simply pressing 1x for a short time on the button on the adapter. Please
wait at least 1 or two ring tones before you press the knob.
Rejecting phone calls
If you do not want to accept the phone call, when it is ringing, you can also reject the call. In
that case please press the knob longer (about 1.5 seconds) after you heard the ring tone(s).
Terminating calls
To end a phone conversation, please press the button on the adapter shortly (or the
appropriate button on your mobile phone). The call will be also finished when the call is
terminated on the distant party's side.
Bluetooth mobile phone dialling
Always stop driving before starting an outgoing call and dialling. It is not allowed to do any
manual action at a mobile phone during driving.
 Use the number pad on the Bluetooth mobile phone for dialling.
 Press the 'Send' button on the Bluetooth mobile phone to dial the number.
 The conversation will automatically be transferred to the headset.
10
.
English