ECG ZH 1321 Mode D'emploi page 9

BEARD TRIMMER
oil gets in your eyes, flush them immediately with
plenty of water. Never swallow the oil.
CAUTION! Property damage
Use original accessories only. Never place the device
on hot surfaces (e.g. hot plates) or near sources of heat
or naked flames. Do not cover the power source to
prevent overheating. To prevent damage to the razor
blade, do not apply excessive pressure to the blade.
Do not remove the shaving foil from the foil frame. Do
not use coarse or abrasive cleaners.
Remember that the battery capacity will get shorter
after longer storage periods. Therefore long charging
times due to interruption between charging and
discharge cycles should be avoided.
Before first use
• After transporting or storing in cold conditions, the device must be allowed
to acclimate at room temperature for at least 2 hours.
CHARGING
Charging
CAUTION! Property damage
Remember that the battery capacity will get shorter after longer storage
periods. Long charging times due to interruption between charging and
discharging cycles should be therefore avoided. We recommend that you fully
discharge the battery before the first charging. Do not charge the trimmer
for more than 24 hours at a time. Do not leave the trimmer permanently
connected to the charging cable.
ATTENTION: Use only the charging cable supplied with the trimmer for
charging. Make sure the switch is in the „OFF" position before
charging.
NOTES
Connect the power cord to the device. Connect the power cable to an easily
accessible PC with a USB interface or to a socket. When the cable is connected
to the power supply, the red LED on the trimmer body lights up permanently.
To extend battery life, we recommend the following charging times:
First charging - charging time about 12 hours
Each additional charging - charging time about 8 hours
1× in six months – we recommend to extend the charging time to about
12 hours.
English
9