Table des Matières
Publicité
OPERATION
WATTAGE INFORMATION
Some appliances need a "surge" of energy when starting. This means that
the amount of electrical power needed to start the appliance may exceed
the amount needed to maintain its use.
Electrical appliances and tools normally come with a label indicating
voltage, cycles / Hz, amperage (amps) and electrical power needed to run
the appliance or tool.
Check with your nearest dealer or service provider with questions regard-
ing power surge of certain appliances or power tools.
• Electrical loads such as incandescent lamps and hot plates require the
same wattage to start as is needed to maintain use.
• Loads such as fluorescent lamps require 1.2 to 2 times the indicated
wattage during start-up.
• Loads for mercury lamps require 2 to 3 times the indicated wattage
during start-up.
• Electrical motors require a large starting current. Power requirements
depend on the type of motor and its use. Once enough "surge" is
attained to start the motor, the appliance will require only 30% to 50%
of the wattage to continue running.
• Most electrical tools require 1.2 to 3 times their wattage for running
under load during use. For example, a 5000 watt generator can power
a 1800 to 4000 watt electrical tool.
• Loads such as submersible pumps and air compressors require a very
large force to start. They need 3 to 5 times the normal running wattage in
order to start. For example, a 5000 watt generator would only be able to
drive a 1000 to 7000 watt pump.
To determine the total wattage required to run a particular electrical
appliance or tool, multiply the voltage figure of the appliance / tool by
the amperage (amps) figure of same. The voltage and amperage (amps)
information can be found on a name plate which is normally attached to
electrical appliances and tools.
CAUTION
If an electric motor fails to start or reach running speed, turn off the
appliance or tool immediately to avoid equipment damage. Always
check the requirements of the tool or appliance being used compared
to the rated output of the generator.
20
OPERATION
SPARK ARRESTER
The spark arrester must be cleaned regularly to keep it functioning as
designed.
A clogged spark arrester:
• Prevents the flow of exhaust gas
• Reduces engine output
• Increases fuel consumption
• Makes starting difficult
CAUTION
If engine has been running, the muffler and the spark arrester will be
very hot. Allow the muffler to cool before cleaning the spark arrester.
HOW TO REMOVE THE SPARK ARRESTER
1. Remove the flange bolts from the muffler cover and remove the muffler
cover.
2. Remove the special screw from the spark arrester and remove the
spark arrester from the muffler.
CLEAN THE SPARK ARRESTER SCREEN
1. Use a brush to remove carbon deposits from the spark arrester screen.
Be careful to avoid damaging the screen.
2. The spark arrester must be free of breaks and holes. Replace the
spark arrester if it is damaged.
3. Install the spark arrester, and muffler protector in the reverse order
of disassembly.
If you have any problems with the operation of your generator, please
call the generator help line at 1-866-850-6662. If calling for assistance,
please have the model and serial number available.
21
Publicité
Table des Matières
