Tiiwee PowerPlus Manuel D'utilisation page 3

Installation
• The device can be mounted on a flat and smooth surface with adhesive tape.
• The location for the device should meet the following requirements:
• Rooms with exterior windows, so the dusk sensor is exposed to darkness and will be
activated when dusk sets in.
• The dusk sensor can also be activated by street lights or car headlights on busy roads.
• The device may be not visible from the outside.
• The power supply must be within reach of the adapter.
• The projected light of the device must be visible on the walls and ceiling from outside.
Operation
Switch on / off
The function switch can be found on the back of the unit. There are four positions available.
Switch ON
Slide the function switch to the ON position to turn on the TV Simulator.
Switch on for 4 or 7 hours by dusk sensor
At dusk, the device switches itself on and simulates a colour television set flickering light for 4 or
7 hours.
When exposed to light (>ca. 30lux), the TV Simulator also switches off before the 4 or 7 hours
have lapsed.
• Slide the function to the switch +4 position to activate this function.
• A red LED will illuminate to indicate that the device in this mode is available.
• Slide the function switch to the +7 position to activate this function.
• Two blue LEDs will illuminate to indicate that the device in this mode is available.
Switch Off
Slide the function switch to the OFF position to turn off the TV Simulator.