Summit SU82090 Mode D'emploi page 6

5
INSTALLATION
Before proceeding YOU MUST properly attach a
FBFAHS with Lineman's Belt in order to support your
weight. Read, understand and follow your FBFAHS
instructions and warnings. A FBFAHS with Lineman's
Belt MUST BE USED AT ALL TIMES when installing,
removing or using any fixed position climbing aid or
fixed position treestand. If you do not have a FBFAHS
(one should have been provided with your treestand)
do not install or use this product.
1. Prior to hanging any Climbing Aid, the use of a Full Body Fall Arrest Harness System is required using the Lineman's Belt
included with the FBFAHS.
The FBFAHS is NOT included with this product but it is REQUIRED for installation, removal and use of this product. If you
do not have a FBFAHS, do not use this product. Failure to properly attach and use a FBFAHS from the moment you leave
the ground until you return to the ground could lead to serious injury or death.
2. Select a straight, healthy tree without any obstructions (branches or limbs).
3. Two (2) or more able adults are required when attaching climbing aid to a tree.
4. Insert one end of the Cam Buckle strap over the Strap Cleat (item C) as shown in figure 7. Bring the loop over both ears on
the Strap Cleat as shown in figure 8. Pull tight to secure. See figure 9.
IMPORTANT: The strap must be secured as shown in figure 9.
NOTE: The strap should exit on the tree side of the Strap Cleat as shown in figure 8 and 9.
5. Position the Climbing Aid so that it is straight and vertical. Loop the Cam Buckle strap around the tree and attach the other
looped end to the other Strap Cleat using the steps shown in figure 7 - 9.
6. Pull the free end tight to secure.
7
9
PG 6
WARNING
!
!
ALWAYS ENSURE that the U-shaped stand-off
brackets on each section are on the same side once
assembled.
8
!
The looped end MUST be hooked around both ears as shown
in Figure 9.
WARNING
WARNING
www.summitstands.com