Bostitch N66BC-1 Manuel D'instructions Et D'entretien page 6

LOADING THE N66BC
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
1. Open the magazine:
Pull down door latch and swing door/magazine cover outward. Fig.A
2. Check Adjustment:
The nailer must be set for the length of nail to be
used. Nails will not feed smoothly if the magazine
is not correctly adjusted. The magazine contains an
adjustable nail platform on which the nail coil rests.
The nail platform can be moved up and down to three nail settings.
To change setting pull up on the post and twist to the correct step. Fig.B
1-1/4" - 1-1/2" (32-40mm) nails - use upper step
1-3/4" - 2" (45-50mm) nails - use middle step
2-1/4" - 2-1/2" (55-65mm) nails - use bottom step
3. Load the coil of nails:
Place the coil of nails over the post in the magazine. Uncoil enough nails
to reach the feed pawl. Place the first nail in front of the front tooth on the
feed pawl, in the driver channel. The nail heads must be in the slot in the
nose. Fig. C and Fig. D
NOTE: Use only nails recommended by Bostitch for N66BC series nailers or
nails which meet Bostitch specifications.
4. Swing cover closed:
To aid in the feeding of plastic collated nails the tab on the cover should
be repositioned. To do so apply pressure to the top center of the tab and
simultaneously apply pressure to the bottom outer edge of the tab until
it rests on the top outer brim of the cover. Swing the door/magazine cover
closed. Check that the latch engages when released. (If it does not engage,
check that the nail heads are in the slot in the nose.)
5. Removal of plastic strip:
As nails are driven, the plastic strip will feed out of the tool. When sufficient
strip has been fed out, it can be torn away by pulling against the tear edge
in the nose. Fig. E
-6-
A
B
C
D
E