koban KMDL-01 Manuel D'instructions page 39

KMDL-01
Pen-type Digital Multimeter
instrument.
Button function
Mode button: Chose DC/AC when you Measure voltage or
Current, Chose resistance, diode, continuity when you measure
resistance, diode, continuity.
Range button: manual change range or Auto change range.
Hold button: Freeze the current test value.
Power OFF
Rotate the function switch to the character "OFF" on the
instrument for Turnning off the power.
7.DC/AC Voltage Measurements
Caution: DO not measure DC/AC voltages if a motr on the circuit
is being switched ON or OFF. Large voltage surges may
occur that can damage the meter.
Rotate the function switch to the character "
instrument, press Mode Button to choose DC or AC Voltage,
Touch
the black test probe tip to the negative side of the circuit. Touch
the metal probe tip to the positive side of the circuit. Read
the voltage in the display.
8.Resistance Measurements
Rotate the function switch to the character "
instrument
•Press the MODE button to change "Ω", "
display.
•If the resistance is less than approximately 30Ω, the audible
signal will sound.
•Touch the test probes to the diode under test. Forward voltage
will typically indicate 0.400 to 0.700V. Reverse voltage
6
" on the
" on the
", " " on the
www.grupotemper.com