HUBITOOLS HU31010 Manuel D'instructions page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Meter Functions –Audible Continuity (
IMPORTANT: Turn the power OFF on the test circuit
Select the Audible Continuity "
mode button.
Insert:
 Black lead in COM terminal.
Ω
-RPM terminal.
 Red lead in V-
Connect one test probe to each end of the circuit to be tested.
 Circuit complete, the meter will beep continuously.
 Circuit open, there is no beep and the display shows to OL (over limit).
Meter Functions –AC or DC Current (A)
IMPORTANT: All current measured flows through the meter.
It is important that you do not:
 Measure current greater than 600 Volts AC or DC, with respect to
ground.
 Do Not Exceed 30 seconds when measuring continuous current
between 1A-20A. Allow five minutes for cool down before continuing.
Select the "20A" or "mA" range with the rotary switch.
Press the Mode button to select AC or DC.
Insert:
 Black lead in COM terminal.
 Red lead in the 20A or mA terminal (select 20A if you are unsure of the
current draw).
IMPORTANT: Turn OFF all power to the circuit or disconnect the circuit
from the power source.
Connect:
)
" function with the rotary switch and
Ω
Ω
Ω
Ω

Publicité

Table des Matières
loading

Produits Connexes pour HUBITOOLS HU31010

Table des Matières