Disposing Of The Appliance; Using The Appliance For The First Time; Turning On And Heating Up; Making Coffee Using Coffee Beans - Barazza 1CFFY1 Mode D'emploi

Important! Safety cutout devices must be included
in the mains power supply in compliance with the installation
regulations in the country concerned.

Disposing of the appliance

The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
USING THE APPLIANCE FOR THE
FIRST TIME
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill.
• Customise water hardness as soon as possible following the
instructions in the "Setting water hardness" section.
1. Connect the appliance to the mains supply. Press the ON/
stand-by button (A7).
Set the required language.
2. To set the language, use the
choose the required language (fig. 2). When the message
"PRESS OK TO CHOOSE ENGLISH" is displayed, press the OK
icon (B9) (fig. 3) for 3 seconds until "ENGLISH INSTALLED"
is displayed. If you set the wrong language, follow the
instructions in the "Setting the language" section. If your
language is not available, select one from those displayed.
The instructions refer to the English version. Then follow
the instructions displayed:
3. After 5 seconds, the appliance displays "FILL TANK". Extract
the water tank (fig. 4), rinse and fill with fresh water wi-
thout exceeding the MAX line.
Replace and push as far as it will go.
4. Place a cup under the cappuccino maker (fig. 5).
The appliance displays: "HOT WATER PRESS OK".
Press the OK icon (B9) (fig. 3) and after a few seconds a little
water comes out of the spout.
5. The machine now displays "TURNING OFF... PLEASE WAIT"
and goes off.
6. Extract the appliance by pulling it out using the handles
(fig. 6). Open the lid and fill the container with coffee be-
ans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.
Important! Never introduce pre-ground coffee, freeze
dried coffee, caramelised beans or anything else which could
damage the appliance.
need to make 4-5 cups of coffee and 4-5 cappuccinos before the
appliance gives satisfactory results.
OFF switch (A23), it performs a SELF-DIAGNOSIS cycle and then
goes off. To turn it on again, press the ON/OFF button (A7) (fig. 1)

TURNING ON AND HEATING UP

Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
flows from the coffee spouts.
To turn the appliance on, press the ON/OFF/stand-by button (A7)
(fig. 1). The message "HEATING UP... PLEASE WAIT" is displayed.
When heating is complete, the message changes to "RINSING";
The appliance is at temperature when the message "MEDIUM
icons (B7 and B8) to
CUP NORMAL TASTE" is displayed.
If no icon is pressed within about 2 minutes, the time (if set, see
the "Setting the clock" section) is displayed.
If the time has not been set, the appliance displays the last fun-
ctions set.
When any icon is pressed, "MEDIUM CUP NORMAL TASTE" is di-
splayed again. The appliance is ready to make coffee again.
MAKING COFFEE USING COFFEE
BEANS
1. The appliance is preset to make coffee with a normal taste.
2. Place 1 cup under the spouts to make 1 coffee (fig. 9) or 2
3. Press the
6
N.B.: When using the appliance for the first time, you
N.B.: Each time you turn the coffee maker on by the ON/
Danger of burns! During rinsing, a little hot water
You can also choose coffee with an extra-mild, mild, strong
or extra-strong taste. There is also a pre-ground coffee op-
tion. To choose the required taste, press the
(fig. 7) a number of times. The required coffee taste is di-
splayed.
cups for 2 coffees (fig. 8). Lower the spouts as near as possi-
ble to the cup for a creamier coffee (fig. 10).
icon (B5) (fig. 11) to select the type of coffee:
espresso, small cup, medium cup, large cup, mug.
Now press the icon (B10) (fig. 12) if you want to make a
coffee and the icon (B11) (fig. 13) if you want to make
EN
icon (B4)