Harman Veroval BPW 22 Mode D'emploi page 72

Table 4
Recommended separation distances between portable and mobile RF communications equipment and the Veroval
The Veroval ® BPW 22 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or
the user of the Veroval BPW 22 can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile
®
RF communications equipment (transmitters) and the Veroval
communications equipment.
Rated maximum Separation distance according to frequency of transmitter
output power of m
transmitter
150 kHz to 80 MHz (out ISM and
W
amateur radio bands)
d = 1.2
0.01 0.12
0.1 0.38
1 1.2
10 3.8
100 12
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
® BPW 22 as recommended below, according to the maximum output power of the
150 kHz to 80 MHz (in ISM and amateur
radio bands)
d = 2
0.2
0.632
2
6.32
20
72
BPW 22
®
80MHz to 800MHz 800MHz to 2.7GHz
d = 1.2 d = 2.3
0.12 0.23
0.38 0.73
1.2 2.3
3.8 7.3
12 23