Conrad FHT80TF-2 Mode D'emploi page 23

d) Mounting the magnet
The figure shows how the magnet is aligned to the
device. To achieve maximum range, the height of
the lower edge of the "FHT80TF-2" should be
approx. 12 mm.
The distance between the magnet and the
"FHT80TF-2" should not be greater than 25 mm.
Please observe that only one magnet may be in-
stalled to the left or right. It is not possible to monitor
both sides at the same time.
To bring the magnets and the door/window detector to
the same level, use the spacers (A) if required.
Concerning this, also read chapter 6.e).
You may attach the door/window contact using the included
double-faced adhesive tape or the included screws.
Using double-faced adhesive tape will not damage the doors or
windows. When using double-faced adhesive tape, however,
spacers must not be used for reasons of stability.
• When screwing it on, use the lens head screws (C) for attaching the magnet.
• For hard surfaces, pre-drill the holes with a 1.5 mm drill; for soft surfaces, this is not necessary.
• Attach the magnet holder (B) with screws and then attach the cover cap (D).
23