Audio Connection With Amplifier; Operation And Functions; On, Off And Standby; Adjusting The Antenna - Vieta Home VH-HT010 Manuel D'utilisation

AUDIO CONNECTION WITH AMPLIFIER

Audio connection
Stereo Outpu t
FM ANTENNA AM
RL
Analog amplifier/receiver
VH-HA100BK
- -
+
This page only contains suggestions for connection of your VH-HT010.
Note that the accessories in the pictures on this page are not included in the supply.
28
VH -H T0 10 BK /S L
AC ~2 20 -2 40/ 50H z
20 W
+ LR

OPERATION AND FUNCTIONS

On, Off and standby

1 Turn on and off the unit by pressing the mains switch.
2 Press the Power (standby) button on the remote
AC ~2 20 -2 40 V/ 50H z
control to switch into
standby mode and power on again.
3 If you wish to turn off the unit to avoid any power
consumption, you must
FU SE :T 0. 5A L 2 50 V
press the mains switch.
1
3
3. Protect the environment and turn off the unit
after use.

Adjusting the antenna

As it applies to all other radios, the sound quality
depends on the signal strength of the antenna position
and direction at the backpanel side.
The position of the radio in relation to the transmitter
thus directly influences the quality of the signal
received. For an optimal result it is therefore very
important that you make sure that the radio receives
the best possible antenna signal.

RDS

This tuner features RDS on the FM receiver. To
activate the informations, you can press RDS button
on the remote control, like Radio text, Station
frequency, Station type, Time and Date.
Note:
If the RDS button is pressed and no RDS information
displays, you need to check the strength of the signal
and adjust the antenna position and direction; or the
current station does not broadcast the information at
all.
Tuner FM/AM
VH-HT010BK/SL
FM ANTENNA AM
Adjusting the antenna
RDS
VH -H T0 10 BK /S L
AC ~2 20- 240/ 50 Hz
20 W
ENGLISH
29