Motorcycle And Car Jump Starting; Disconnecting - AEG 97217 Mode D'emploi

24

Motorcycle and car jump starting

Preparations
4. Be sure to follow the indications on jumpstarting inside the vehicles' operator's
manuals.
5. Set the parking brake on both vehicles.
6. Set gearstick to neutral, for automatic transmissions to P.
7. Switch off ignition on both vehicles and all devices.
8. Do not disconnect the drained battery from the vehicle's electrical system.
Connecting
connect the terminal clamps of the leads in the following order:
1. Positive lead (red) to positive terminal of drained battery.
2. Negative lead (black) to the negative pole on the drained battery, or to a suitab-
le mass (e.g. engine block) on the vehicle.
3. open the jack cover (8) and connect the jumper leads (13) to the Multi Power
Pack.
Starting
Start the engine of the vehicle with the drained battery (starting attempt max. 15
seconds - wait at least one minute between additional attempts to start).

Disconnecting

Caution!
when disconnecting the jumper cables, be careful they do not come into contact
with the moving parts of the engine.
attention! risk of damage from electrical surge!
Disconnect the Multi Power Pack from the vehicle's battery within 30 seconds after
the vehicle ist started to prevent damaging the device.
Disconnect the terminal posts of the cables in the following order:
1. Negative cable (black) from the vehicle's mass point.
2. Positive cable (red).
3. Jumper leads (13) from the Multi Power Pack.
4. close the jack (8) with the cover.