GUARDO DR120 Mode D'emploi page 6

C. CONNECTING THE DRONE WITH THE REMOTE CONTROL
To connect the drone with the remote control, first turn the drone on and put it in a safe spot.
The LEDs will start to blink. Turn the remote control on by using the ON/OFF button (1), the LED
indicator (12) will blink after a few seconds and will then be on continuously. Move the left-control
joystick to the upward and then the downward position to make a connection. The LED indicator
(12) will stay on continuously.
FLIGHT-INSTRUCTIONS
TIP: Practice makes perfect!
We strongly recommend you to check the device for damage before each flight and that the
surrounding is safe enough so you cannot cause any unwanted damages.
Make sure that the batteries are installed and that the drone is connected to the remote control
(see 3b, 3c). Put the drone in a safe spot.
To make the drone take off, press the Take Off/Alt Hold-button (13). It will automatically rise to
approximately 2 meters.
With the left Joystick controller you can make the drone:
Joystick Direction
Down (altitude)
Up (altitude)
Left (rotation)
Right (rotation)
To move the device to the front, back, left or right you can use the right Joystick controller (4).
With this Joystick controller you can make the drone:
Joystick Direction
Down (direction)
Up (direction)
Left (direction)
Right (direction)
FINE-TUNING AND OTHER FUNCTIONS
It can happen that the drone becomes off-balance because of air movements while flying.
Therefore, you can give small commands to restore this balance. This is done by using the fine-
tuning buttons (2, 3).
Drone Reaction
Altitude will decrease
Altitude will increase
Drone will rotate to the left and change direction
Drone will rotate to the right and change direction
Drone Reaction
Drone will move to the back
Drone will move to the front
Drone will move to the left
Drone will move to the right
-6-