Description Of Symbols; General Safety - Silverline 633665 Mode D'emploi

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Read instruction manual
Specification
Image: ..................................................Erect
Magnification: ......................................X20
Objective aperture: ...............................34mm
Field of view: ........................................1°20'
Minimum focus: ...................................0.5m
Multiplication constant: ........................100
Additive constant: .................................0
Compensator range: .............................±15'
Compensator setting accuracy: ............±0.8'
Sensitivity of bubble: ............................8'/2mm
Horizontal circle - reading: ...................1° or 1 gon
Instrument net weight: .........................1.55kg
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
4

General Safety

Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
Trained, competent persons
• This tool should be used by trained, competent persons only
Children and pets
• Keep children and pets at a safe distance from the work area. Lock tools
away where children cannot gain access
Use the correct tool
• Do not force or attempt to use a tool for a purpose for which it was not
designed. This tool is not intended for industrial use
Keep your balance
• Do not over-reach. Keep proper footing at all times and do not use tools
when standing on an unstable surface
Accessories
• The use of any attachment or accessory, other than those mentioned in
this manual, could be dangerous and result in damage or injury, and may
invalidate your warranty
Never stand on your tool
• Standing on your tool or its stand could cause serious injury if the tool is
tipped or collapses. Do not store materials above or close to the tool in
such a way that a person might stand on the tool to reach the
stored items
Check for damaged or missing parts
• Before each use, check if any part of the tool is damaged or missing.
Carefully check that it will operate properly and perform its intended
function. Check alignment of moving parts for binding. Any guard or other
part that is damaged should be immediately repaired or replaced by an
authorised service centre. DO NOT USE IF DEFECTIVE
Additional Safety Instructions
for Automatic Optical Level
• Protect the instrument from excessive movement or knocks.
Always transport the instrument in the case provided
• Do not look through the lens directly towards the sun or into direct
sunlight as this could result in loss of eyesight. Always use a filter when
facing direct sunlight
• Check the levelling and indication accuracy of the measuring tool each
time before using and after longer transport of the measuring tool
• Protect the measuring tool against moisture and direct sun light
• Do not subject the measuring tool to extreme temperatures or variations
in temperature. As an example, do not leave it in vehicles for long time.
In case of large variations in temperature, allow the measuring tool to
adjust to the ambient temperature before putting it into operation
• In case of extreme temperatures or variations in temperature,
the accuracy of the measuring tool can be impaired
• If the level has been knocked or has encountered excessive movement,
it is recommended to carry out an accuracy check each time before
continuing to work