Electrolux A85280-GA Notice D'utilisation page 35

2. Remove the ventilation grille. Remove the filling an install it on the opposite side of
the grille.
3. Lay down the appliance back side down on a wooden support.
4. Unscrew the lower hinge (a1).
Remove the door closure device from the
hinge and move the pin to the other side
(a2). Re-screw the door closure device
provided within the accessory bag on the
opposite side.
5. Remove the door closure device on the
door (b1).
Re-screw the door closure device provi-
ded within the accessory bag on the op-
posite side (b2).
6. Remove the door.
Unscrew and move the pin to the opposite
side.
7. Re-insert the door.
Re-screw the lower hinge.
Raise the appliance and install the venti-
lation grille.
8. Unscrew the handle. On the opposite side
remove the hole covers by driving a 3-4
mm drift or drill into them.
Install the handle. Fit the handle on to the
opposite side by turning it on half circle.
Install the hole covers provided within the
accessory bag.
9. Put the cabinet in position.
WARNING!
Reposition, level the appliance, wait for at
least four hours and then connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the side edge of the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
Installation
a1
b1 b2
180°
35
a2