Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not sand plaster surfaces,
(WARNING: In this case your
guarantee becomes void) this
may clog the motor (brushes,
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
Your orbital sander has been designed for
sanding applications.
1 ON/OFF Switch button
2 Lock button
3 Main handle
4 Dust bag
5 Hook and loop sanding plate
6 Front handle
OPERATING INSTRUCTIONS
Switching on and off
To switch on the machine press the on/off
switch (1).
To switch off the machine, release the
on/off switch (1).
To switch the machine to continuous
mode, you keep the on/off switch (1) fully
pressed and simultaneously press the
lock button (2). And subsequently release
the on/off switch.
To switch off continuous mode, press the
on/off switch (1) again.
Never use the machine for
sanding magnesium workpieces.
Fitting sanding sheets
Take sanding paper of the required grain
size and place it on the sanding pad .
Make sure that the perforations in the paper
correspond with those on the sanding pad.
Press the paper firmly on the sanding pad.
The sanding paper must be
fitted firmly on the sanding pad
and should not come loose.
Dust extraction
The dust extraction outlet together with the
dust bag takes care of the dust extraction of
the working surface.
Slide the dust bag (4) onto the connection.
Regularly empty the dust bag to ensure
optimum dust extraction.
ball bearings, ..).
CLEANING AND MAINTENANCE
Attention! Before performing
any work on the equipment,
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
§ Damaged switches must be replaced by our after-
sales service department.
§ If the connecting cable (or mains plug) is
damaged, it must be replaced by a particular
connecting cable which is available from our service
department. Replacement of the
connecting cable must only be carried out by our
service department (see last page) or by
a qualified person (qualified electrician).
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a
regular basis.
_
Remove the carbon brush holders (3) and
clean the carbon brushes.
_
In case of wear, replace both carbon brushes at
the same time.
_
Mount the carbon brush holders.
_
After mounting new carbon brushes, let
the machine run at no load for 15 minutes.
Use only the correct type of
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
-1
Orbits min
Sanding surface mm ø
Weight kg
Acoustic pressure level
L
78 dB(A) K =3 dB(A)
PA
Acoustic power level
L
89 dB(A) K = 3 dB(A)
WA
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
pull the power plug.
carbon brushes.
230-240
50
180
11.000
125
1.34
ATTENTION !
must be worn.
Publicité
Table des Matières
