Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2
Introduction
Introduction
Congratulations on your purchase of PHILIPS Multi-video input
A/V switcher. Your A/V switcher is designed to accept up to 4
signals from any AV equipment and deliver them to a TV or a
Home Theater System. The switcher accepts video input signals
from component, s-video or composite video sources and audio
input signals from a stereo audio source to provide a single
audio/video output to your TV. NOTE:The switcher can con-
vert an s-video signal to composite video, and vice versa. But it
can not convert component video signals.The switcher is
designed to operate either in Manual mode or Automatic mode.
Parts Required
You will need the following items, not supplied with your AV
switcher.
Stereo audio cable
Component video cable OR
S-Video cable OR
Composite Video cables
Connection
Follow these steps to connect your AV Switcher.
• Connect one end of a video cable plug (S-Video, composite
video or component video) to the output jack(s) of your
video source then connect the other end of a video cable
plug to any one of the input jacks on your AV switcher.
• Connect the stereo audio cable plugs between the audio out-
put jacks of an audio source and the audio input jacks (red &
white) on your AV switcher.
• Connect a video and an audio cable between the video and
audio output jacks of the AV switcher and the video and
audio input jacks of your TV.
• Connect DC power plug on the back of the unit and plug the
2-pin AC/DC power adapter to an 120VAC outlet.
Note: You must use matching cables for input and output con-
nections in order for the unit to work properly. (for example, if
you use a component video cable as an input, you must use a
component video cable for output.)
Publicité
Table des Matières
