Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Mounting & installation
continued
Concrete Wall (fasteners not included)
You will need; (4) 3/8" x 2-1/4" concrete sleeve
anchors.
1.
Drill a 3/8" x 1-3/4" hole with a masonry drill bit.
2.
Insert a bolt and anchor sleeve into the hole.
3.
Align the bracket over the hole and mark
remaining hole locations using the (4) outer
holes of the mounting bracket; remove
bracket and drill remaining holes.
4.
Mount the bracket starting at top corner hole,
tightly securing sleeve anchor with hex nut.
5.
Repeat for three remaining holes.
6.
Mount the unit by making sure the two
square slots on backside of unit are sitting
on the two hooks on the mounting bracket.
Mounting the Hose Holder (fasteners included)
1.
Determine desired location for hose holder
and screw 1-1/4" screw into stud.
(If mounting into drywall with no stud
available, use supplied drywall anchors)
2.
Hang holder from screw and insert 2-1/2"
screw in bottom hole of hose holder to finish
mounting.
3.
Wrap hose around holder.
Operations
Power switch
The power switch is located on the top left side
of the vacuum.
To turn vacuum on, ( I ) press up.
To turn vacuum off, ( O ) press down.
www.BISSELL.com
6
Use (4) Outer Holes
To Mount Bracket
Slots
WARNING:
Do not remove plastic covering on
power switch.
Power Switch
1-800-237-7691
Operations
Wet or dry vacuuming mode
1.
Attach hose to the wet/dry hose inlet
opening (located on the front left side of the
unit) by pushing fitted end of hose and
turning clockwise until you feel it is secure.
2.
Attach extension wand, if desired, to end of
hose by pushing it firmly into the hose.
3.
Attach additional wand or tool, if desired, by
firmly inserting onto the wand.
4.
Plug in the unit and push the power switch
up to begin vacuuming.
Blower mode
1.
Attach hose to the blower hose outlet
opening (located on the right side of the unit
on top of muffler) by inserting fitted end of
hose and turning clockwise until it is locked
in and secure.
2.
Attach extension wand, if desired, to end of
hose by pushing it firmly into the hose.
3.
Attach additional wand or tool, if desired, by
firmly inserting onto the wand.
4.
Plug in the unit and push the power switch
up to begin blowing.
Safety device
1.
The vacuum has a protection device to
automatically power off when the tank reaches
its water capacity (this prevents water from
reaching the motor). If this happens, the red
light will turn on indicating the tank needs
immediate emptying.
2.
If the temperature exceeds the unit's limit,
the thermal protection device will turn on and
automatically power off the unit. If this
happens, wait 30 minutes prior to restarting
the vacuum.
3.
In the event of a clogged or full dirt tank, the
yellow light will turn on indicating the dirt tank
and filter need cleaning. To ensure best
performance, clean the tank and filter every
15-30 days.
1-800-263-2535
WARNING:
Do not tamper with float/water sensor.
Always make sure the float/water sensor is
in the dirt tank and not outside of the tank.
Float/
Water
Sensor
CAUTION:
Do not run any objects including cars
over hose.
WARNING:
Do not suck up volatile or flammable
liquids such as gasoline, kerosene or oil.
www.BISSELL.ca
7
Publicité
Table des Matières
