Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Introduction:
Thank you for purchasing our product for the safety and comfort of your vehicle. Despite its
uncomplicated installation, we recommend that you consult a professional to avoid damaging your
vehicle.
Before installation:
- Comply with the rules in force in your country for the use and installation of this product.
- For your safety, please observe the following installation instructions.
- The monitor must be placed in a location that provides good visibility for the driver.
- The system operates on 12V DC voltage only, check the vehicle voltage, and the polarity of each
connector.
- Before installation, check that all vehicle components function correctly, such as contact, starter, light
code ignition and headlights... And carry out the same tests after installation.
- Connect the wires only by soldering or splicing. Bad contacts can create serious vehicle and system
malfunctions.
- Make sure that the system is properly grounded.
System connection :
Screen
Mount the rubber bracket of the monitor clip on the original car mirror.Make sure there is no loss and
run through the cable connecting the car ceiling to the car power supply.
Using the system:
- Infrared receiver of the remote control
- ON / OFF button allows switching on and off.
- Source change button
- Button to decrease levels
- Menu access button
- Button to increase levels
- Button to change mode
The menu contains all the settings for the display.
Each time you press the MENU button, you can move to the
next command: Brightness, contrast, color, format, language,
reset...
The green wire connected to the +12V
reverse switch allows the system to switch
automatically as soon as the reverse gear is
switched on, even when the system is
switched off.
Publicité
Table des Matières
