Battery - Stiga BT 520 Li 48 Manuel D'utilisation

Fuse
T3.15A/250V
CE conformity marking
Do not dispose of this product
with domestic waste.

3. BATTERY

SPECIFICATIONS
BT 520 Li 48
Battery: 48V Max., 86,4 Wh
Cell voltage: 3.6V ; Number of cells:12
Charging time: 90 min.
(using a CG 500 Li 48 Charger, CGD 500 Li 48
Charger)
Charging time: 50 min.
(using a CGF 500 Li 48 Charger)
BT 540 Li 48
Battery: 48V Max., 172,8 Wh
Cell voltage: 3.6V ; Number of cells: 24
Charging time: 180 min.
(using a CG 500 Li 48 Charger, CGD 500 Li 48
Charger)
Charging time: 110 min.
(using a CGF 500 Li 48 Charger)
BT 550 Li 48
Battery: 48V Max., 216 Wh
Cell voltage: 3.6V ; Number of cells: 24
Charging time: 220 min.
(using a CG 500 Li 48 Charger, CGD 500 Li 48
Charger)
Charging time: 120 min.
(using a CGF 500 Li 48 Charger)
For proper use, maintenance and storage of the
battery, it is important to read and understand
the instructions provided in this manual.
In order to avoid serious injuries, fire
hazards, explosions and dangers from
electric shocks and electric arcs:
• DO NOT probe the charger with conductive
materials. The charging terminals
can withstand a voltage of 120 V.
• If the battery pack case is broken or
damaged, DO NOT insert it into the charger.
Replace it with a new battery pack.
• DO NOT charge these battery packs
using a different type of charger.
• DO NOT allow liquid to get inside the charger.
• DO NOT use the charger for other purposes
than those specified in this manual.
• DO NOT attempt to short-circuit
the battery pack terminals.
If chemicals in the battery come
into contact with the eyes, wash them
immediately with clean water for at
least 15 minutes. Seek medical care
immediately. Do not recharge the battery
pack in rain or humid conditions. Do
not immerse the tool, battery pack or
charger in water or other liquids.
• Be aware that the battery pack or charger
do not overheat. If they are hot, let them cool
down. Charge only at room temperature.
• Do not cover the ventilation grids on the top
of the charger. Do not place the charger on a
soft surface such as a blanket or pillow. Keep
the ventilation grids of the charger clean.
• Prevent small metal objects or materials
such as steel wool, aluminium foil,
or other extraneous particles from
entering the charger cavities.
• Unplug the charger before cleaning or
when there is no battery pack inside.
• DO NOT place the battery pack in direct
sunlight or in a warm environment. Always
keep it at a normal room temperature.
• DO NOT attempt to connect two
chargers at the same time.
• If the battery is not charged for a long
time, it should always be stored in the
shade, in a cool and dry place.
• Charge the battery for 2 hours every 2 months.
• The cells in the battery pack may leak if used
too much or at extreme temperatures.
• If the outer seal breaks and chemicals in the
battery come into contact with the skin:
– wash immediately with soap and water,
– neutralise with lemon juice,
vinegar or other mild acids.
• If chemicals contained in the battery come into
contact with the eyes, follow the instructions
above and seek medical assistance.
• Before use, check that the output voltage
and current of the battery charger are
suitable for charging the battery pack.
• If the output polarity does not match the
charging polarity, DO NOT use the charger.
• For indoor use only.
• DO NOT open the cover under any
circumstances. If the cover is damaged,
the charger can NO longer be used.
• DO NOT charge non-rechargeable batteries.
EN - 2