Electrical Characteristics; Recommended Mounting Heights; Important - Bobrick TrimLine B-7120 Instructions D'installation

Table des Matières

Les langues disponibles

model B-7120 White Painted steel cover and B-7128 stainless steel cover, 115V AC, 15 Amp, 1725 Watts, 50/60 Hz, Single Phase, cULus listed.

model B-7120 White Painted steel cover and B-7128 stainless steel cover, 208–240V AC, 6.8-7.8 Amp, 1400-1900 Watts, 50/60 Hz, Single

Phase; cULus listed, VDE and CE marked.

Installation instructions and template provide information that will assist in the installation of the Bobrick B-7120 and B-7128 115V, B-7120 and B-7128

208-240V. Retain Installation Instruction Sheet for important maintenance instructions and warranty information.

Distance from floor to bottom mounting screw holes of mounting base.

Children's Washrooms, ages 3-4 .............................................................................................................................................................. 36'' (915mm)

Children's Washrooms, ages 5-8 .............................................................................................................................................................. 40'' (1015mm)

Children's Washrooms, ages 9-12 ............................................................................................................................................................ 44'' (1120mm)

Universal Design ...................................................................................................................................................................................... 48'' (1219mm)

Bobrick automatic hand dryers should be installed at least 15" (380mm) above any projection or horizontal surface which may interfere with the

operation of the automatic sensor.

Warm air hand dryer. Intended for use in a household environment by non-expert users. not suitable for outdoor use.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the hazards involved. children shall not play with the appliance.

cleaning and user maintenance shall not be made by children without supervision.

***

If a fault develops disconnect the electrical supply, a qualified electrician should be called.

1. Start installation of dryer by

removing cover. Remove two

screws, from the bottom of the

dryer.

for ProPer eLecTrIcaL connecTIons, cHecK LocaL

BuILdInG code. unIT musT Be InsTaLLed By a QuaLIfIed

LIcensed eLecTrIcIan

1. Hold the Installation Template against the wall in the desired location of

the installed dryer. See recommended mounting heights above.

2. Make sure line on template representing bottom of dryer mounting base

is horizontal and located at the desired height above floor.

3. Mark center of four mounting screw holes and hole for entry of electrical

wiring if electrical supply is concealed in wall and will enter dryer from

back through mounting base.

NOTE: Surface-mounted electrical supply entry is located in the lower right

corner of the mounting base. Surface-mounted supply cable should be fitted

in a conduit.

4. For brick, stone, and concrete walls drill four 0.315" (8mm) holes to suit

wall plugs 0.315" (8mm) x 1-1/4" (45mm) and screws#10 (4.8mm) x 2"

(50mm) long (provided). See template for wall plug and screw

installation details.

5. For plaster or dry wall construction, provide concealed backing to

comply with local building codes and secure with four #10 (M4.8) round-

head sheet-metal screws, or 3/16'' (5mm) toggle bolts (not furnished).

6. Fasten mounting base securely to wall.