Richen EF42C Instructions D'utilisation page 28

E N
N OT E: Remote control can be used only when the main power switch
is on. Aim the remote control at the remote receiver (see last picture)
which is on the top right of the firebox.
R E S E T TI N G T H E T H E R M A L C U T O U T
The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance over-
heats, e.g. when covered. If the heater stops operating while the flame effect
continues working normally, this indicates that the E.S. Control is in operation.
The E.S. Control can only be re -set after the appliance has cooled down,
and the appliance has been reset. Re -setting of the E.S. Control proceeds is
as follows:
1. Switch off the appliance (Manual On / Off switch) and leave it off for
approximately 10–15 minutes.
2. Remove any obstruction to the fan heater outlet or fan blades etc.
Make sure that the power supply is disconnected with the plug socket
outlet while doing this.
3. Switch on the appliance and the E.S. Control will be re -set.
4. Ensure that the appliance is functioning correctly. If the E.S. Control
doesn' t operates again, the appliance should be checked by a
competent electrician.
28