TRUCK PAC ES-6000 Manuel De L'utilisateur page 4

soap and water. If acid enters eye,
immediately flood eye with running
E
cold water for at least 10 minutes
N
and get medical attention
G
immediately.
L
• NEVER smoke or allow a spark or
I
flame in vicinity of battery or engine.
S
H
• Be extra cautious to reduce risk of
dropping a metal tool onto battery. It
might spark or short circuit battery or
other electrical part that may cause
explosion.
• Remove personal metal items such
as rings, bracelets, necklaces and
watches when working with a lead-
acid battery. A lead-acid battery can
produce a short-circuit current high
enough to weld a ring or the like to
metal causing a severe burn.
• Use portable power source for
charging or boosting LEAD-ACID
battery only. Do not use for charging
dry-cell batteries that are commonly
used with home appliances. These
batteries may burst and cause injury
to persons and damage to property.
• NEVER charge or boost a frozen
battery.
• NEVER allow clamps to touch
together or to contact the same piece
of metal to prevent arcing.
• Use of an attachment not
recommended or sold by the
manufacturer, may result in a risk of
damage to the unit, or injury to
personnel.
• When using the wall charger or
power extension cord, pull on the
plug and NEVER ON THE WIRE
when disconnecting.
• Do not recharge the portable power
source with a damaged wall charger
or power extension cord. Replace
them immediately.
• The portable power source may be
used under any weather condition.
Rain, snow, hot, or cold temperatures.
However, recharging the unit should
only be done indoors.
4
• Do not submerge in water.
• Do not operate with flammables
such as gasoline etc.
• If the portable power source receives
a sharp blow or is otherwise
damaged, in any way, have it
checked by a qualified service
person. If the portable power source
is leaking battery acid do not ship it.
Take it to the closest battery recycler
in your area.
• Do not disassemble the portable
power source. Have it checked by a
qualified service person.
• The portable power source should
never be left in a total discharged
state for any period of time. Damage
to the battery could be permanent
with poor performance as a result.
When not in use, leave the portable
power source connected to the wall
charger or recharge every three (3)
months.
OPERATING
INSTRUCTIONS
CHARGING YOUR NEW
PORTABLE POWER
SOURCE
Your Portable Power Source was
precharged at the factory. It is best for the
battery in the Portable Power Source be
kept at full charge. We recommend that
you should leave the Portable Power
Source plugged in to the wall outlet until it
is required for use. The charging circuit is
automatic, and will not overcharge when
using the wall charger. When all the
power level lights and the charged light
come on while charging or the test button
is pressed, your unit is fully charged.
Figure 2. Test Button & Charge Lights