Italiana Camini Adria Installation, Usage Et Maintenance page 41

The answers are listed below in summary form, for further details see the other pages of this document.
1) What do I need to prepare in order to install the boiler-stoves?
Smoke outlet that is at least 100 mm in diameter.
An air inlet in the room that is at least 80 cm².
¾" G outlet and inlet fitting.
¾" G drains connection for overpressure valve.
¾" G load fitting.
A certified electrical connection with a thermal magnetothermic switch 230V +/- 10% 50 Hz.
(assess the division of primary and secondary circuits).
2) Can the boiler-stove work without water?
NO. Using the boiler-stove without water will damage it.
3) Do BASIC – ESPRIT - MAGIC - PRESTIGE boiler-stoves emit hot air?
NO. Most of the heat is transferred to the water.
Emit a small amount in the installation environment in the form of radiation from the glass hearth. It is advisable in any case to use a
radiator in the same room.
4) Can I connect the inlet and outlet of the boiler-stove directly to a radiator?
NO, just like other boilers, it must be connected to a collector from which the water is then distributed to the radiators.
5) Do boiler-stoves also supply hot sanitary water?
Hot tap water can be produced using our preassembled KITS.
6) Can I discharge the smoke from the boiler-stoves along the wall?
NO, a discharge which is conform with standards (UNI 10683/05) must reach the ridge of the roof, and in any case proper functioning
requires a vertical stroke of at least 1.5 meters; avoiding that in case of power outage or wind, a slight amount of smoke forms in the
installation environment.
7) Do I need an air inlet in the room where it is installed?
Yes, to replenish the air used by the boiler-stove for combustion. The smoke extractor draws the air from the room into the combu-
stion chamber.
8) What settings are required on the boiler-stove display?
The desired water temperature. The boiler-stove will then adjust the power accordingly to obtain or maintain this.
For small systems, a mode can be set that ignites and shuts down the boiler-stove accordingly, as the water temperature is reached.
(contact DEALER for initial start up)
9) How often do I need to clean the combustion chamber?
Before you ignite the boiler-stove, every time, when it is off and cold. AFTER HAVING BRUSHED THE EXCHANGER PIPES and
moved the smoke duct cleaning rods (see page 37).
10) Do I need to vacuum the pellet hopper?
Yes, at least once a month when the boiler-stove is not used for some time.
11) Can I burn other fuel apart from pellets?
NO. The boiler-stove has been designed to burn wood pellets that are 6 mm in diameter. Any other material can damage it.
12) Can I ignite the boiler-stove by sending an SMS?
Yes, if the DEALER or an electrician has installed the connection via an optional cable code 621240 to the serial port behind the boi-
ler-stove
CLEANING ACCESSORIES (optional extras)
GlassKamin
(code 155240)
Used for cleaning the
ceramic glass
FAQ
41
Ash vacuum cleaner
without motor
(code 275400)
User for cleaning the
hearth