Mi-T-M Corporation COOL CUT ET-3410-M Manuel D'utilisation page 18

OPERATION (CONTINUED):
EMPTY CHIP COLLECTOR
WARNING: ALWAYS DISCONNECT THE SAW
FROM THE POWER SOURCE BEFORE
CHANGING BLADES, CLEARING CHIPS OR
MAKING ADJUSTMENTS.
CAUTION: ALLOW SAW TO COOL BEFORE
EMPTYING CHIP COLLECTOR. CHIPS MAY
BECOME HOT WHILE CUTTING.
1. Disconnect power cord from receptacle.
2. Remove the T-knob (A) and flat washer securing
chip collector. (Fig. 6)
3. Remove chip collector from the side of the saw.
4. Empty chip collector, using a chip brush to
thoroughly remove all chips and debris from
collector and saw body.
5. Install chip collector onto the saw, add flat washer
and T-knob. Securely tighten. (Fig. 7)
18
Operation
(Fig. 6)
(Fig. 7)
Metal Cutting Saw Operator's Manual