Exquisit BP8602sw Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To remove the floor brush, crevice tool or small upholstery brush, you just have to pull it off.
ASSEMBLING THE MOP CLOTH
Open the water tank lid, fill the tank with water and close it properly again.
Assemble the water tank and attach the cloth.
Now you can vacuum and mop the floor with the appliance.
USE
Once your appliance is fully charged, remove it from the charging base by holding it by its
handle.
Switch it on by pressing the ON/OFF switch. When you are finished, press the ON/OFF
switch again to switch off the appliance.
By pressing the electronic power regulator, the suction power can be adjusted when using
the appliance as a stick vacuum cleaner. Use a low suction power for furniture and other
delicate surfaces and use high suction power for fitted carpet and other floors.
The floor brush can be used for daily cleaning of large surfaces, hard floors or fitted
carpet.
To clean surfaces that are difficult to reach, use the crevice tool supplied. The crevice tool
can also be used for mattresses, couches, curtains or wallpaper.
The small upholstery brush is useful to clean delicate surfaces or tissues without scratching
them.
AFTER USE
If necessary, disassemble the stick and the suction tool used.
After use we advise you to empty the dust collector to avoid smells and mildew that could
be caused by damp dust particles that may have been vacuumed, and also to
guarantee an optimal efficiency during the next use. To do so, see below.
IMPORTANT SAFEGUARDS
Never use the appliance to vacuum hot, glowing objects such as cigarettes, matches etc.
or sharp objects that could damage the filter.
Only use the appliance with the charger supplied.
CLEANING AND MAINTENANCE
Cleaning the filter and the dust collector is extremely important as it allows the optimal use
of your appliance and eliminates the unpleasantness due to bad smells that can occur
after having vacuumed liquids or humid particles.
Remove the dust collector by pressing the release button situated on top of the appliance
and turning the dust collector. We advise you to do this over a dust bin.
19

Publicité

Table des Matières
loading

Table des Matières