Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
adapter. Please use the power adapter provided with this TL-
SG1008D switch.
Port (1-8): The TL-SG1008D switch
10/100/1000Mbps Auto-Sensing RJ45 ports where you will connect
your network devices. The working status can be indicated by the
corresponding LEDs on the front panel.
Chapter 3 Installation
The switch can be either located on a desktop or mounted on a wall.
3.1 Mounting the Switch on a Desk
To locate the switch on a desktop, please follow these steps:
1)
Place the switch on a flat desk.
2)
Inspect the Power Adapter carefully and make sure that it is
properly connected to a power source.
3)
Ensure adequate ventilation space around the switch for dissipating
heat and air.
Note:
Please avoid any heavy thing placed on the switch.
To ensure the stable cable connection, please keep the switch horizontal
on the desktop, with white cover facing up.
3.2 Mounting the Switch on a Wall
There are two wall-mounting slots on the bottom panel of the switch. To
mount the switch on a wall, please follow the steps below.
1)
Drill two holes into the wall. Insert a screw into each hole and leave
a part of its head exposed.
2)
Place the two wall-mounting slots over the screws and slide the
switch down to fasten it.
- 7 -
English
is equipped
with 8
Publicité
Table des Matières
