Installation; Connect Verification Plug - KERN KIB-A12 Manuel D'utilisation

1 Installation

• Connect the verification plug to the KIB-TM display device as follows and then
adjust the weighing system. Once it has been successfully adjusted, the
display device is linked to the verification plug.

1.1 Connect verification plug

Connect the chip in the verification plug to CN7 (5 Pin) in the display device.
KIB-TM Line colour
Main circuit
board
E+ / Sen+ Red
S+ Green
GND Shield
S- White
E- / Sen- Black
Identchip Line colour
main board
IC GND Yellow
IC signal Brown
KIB-A12-IA-e-1910
Connect female Connect male
1 1
3 3
5 5
4 4
2 2
Connect female Connect male
7 7: Identchip GND
6 6: Identchip signal
Load cell
EXC+
SIG+
GND
SIG-
EXC-
Open housing
3