Fein MULTIMASTER FMM 250 Mode D'emploi page 7

M M FMM 250 / M
ULTI ASTER
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
Sound emission
Measured A-weighted sound power level
L (re 1 pW), in decibels: 85
wA
Measuring uncertainty K
A-weighted emission pressure power level
measured at the workplace L
in decibels: 74
Measuring uncertainty K
REMARK: The sum of the measured emis-
sion value and respective measuring inaccu-
racy represents the upper limit of the
values that can occur during measuring.
Wear ear protection!
Measured values determined in accordance
with the corresponding product standard.
Extension cord
If the use of an extension
WARNING
cable is required, its length
and conductor cross-section must be ade-
quate for the applicational case, in order to
prevent a voltage drop in the extension cable,
power loss and overheating of the power
tool. Otherwise, the extension cable and
power tool are liable to electrical danger,
and the working efficiency is impaired.
M FMM 250 Q
ULTI ASTER
, in decibels: 3
wA
(re 20 μPa),
pA
, in decibels: 3
pA
Vibrations
Classification of FEIN
application tools according
to vibration class
VC0
VC1
VC2
VC3
VC4
VC5
*These values are based on a work cycle
consisting of no-load and full-load opera-
tion of the same duration.
Recommended dimensions of extension
cords at an operating voltage of 120 V – sin-
gle-phase a. c., with only one power tool
FMM 250/FMM 250 Q connected:
Cord Size in A.W.G.
18 16 14
Cord Length in Feet
25 100 150
EN
Weighted
acceleration*
2
< 2.5 m/s
2
< 5 m/s
2
< 7 m/s
2
< 10 m/s
2
< 15 m/s
2
> 15 m/s
2
Wire Sizes in mm
0.75 1.5 2.5
Cord Length in Meters
30 60 120
7