Cast Front Installation And Removal; Glass Door / Safety Screen Installation And Removal - Napoleon Arlington GDS20PSB Manuel D'installation Et D'opération

4.1

cast front installation and removal

A.
Lift the top cast piece off of the appliance.
B.
Detach the front cast piece from the side pieces by removing the screws from the brackets located in the
upper inside corner.
C.
Slide the front straight up to remove.
Follow the above steps in reverse order to reinstall the door. Ensure that the bottom of the door meets the door
retainer before closing the latches.
Follow the above steps in reverse order to reinstall the cast front. Ensure that the tabs on the underside of the
front fi t behind the front legs.
B
C
SCREWS
FRONT
4.2

glass door / safety screen installation and removal

NOTE: It is not necessary to remove the cast front, in order to remove
the door.
A.
Lift the top cast piece off of the appliance.
B.
Unlatch the door latches from the door.
C.
Slide the door straight up to remove.
This appliance was shipped complete with a safety screen. It has been
designed to reduce the risk of burns from the hot viewing glass and must be
installed.
A.
Lift the top cast off of the appliance.
B.
Locate the screen between the glass door and the cast front.
C.
Slide the screen straight up to remove.
Follow the above steps in reverse order to reinstall the screen.
BRACKET
4.0 fi nishing
fi nishing
FRONT
TAB
DOOR
RETAINER
FRONT
LEGS
C
B
DOOR
LATCHES
C
GLASS
SCREEN
DOOR
W415-2345 / B / 12.09.19
EN
25