Ezviz Home Sense Magnetic Contact Guide De Démarrage Rapide page 18

2. Install Detector
Make sure the door or window is closed. Paste the foam sticker to the bottom of the
two parts of the detector and then fix them on the selected position, as shown below.
You are recommended to install the main body of the detector on the
immovable place (such as door frame) in case it falls down when you open and
close the door or window.
Maintenance
When the battery runs out, a low battery warning will be sent to the EZVIZ account to remind
you to change the battery.
- If you install the main body on the left, push the main body upwards and take it off from the
rear cover; if you install the main body on the right, pull the main body downwards and take
it off from the rear cover.
- Open the battery cover and then change the battery.
- Install the main body back to the rear cover.
Door/Window Frame
Door/Window
4