M-E Cuveo CT-POUT Mode D'emploi page 15

7. Replace the cover on the motion detector.
STARTUP
Settings on the motion detector
a.) Lift the cover of the motion sensor off the
base part.
b.) If the battery compartment is at the top,
a slide switch (1) will be located below it
for setting the ON time of the programmed
Cuveo receiver. A time of 5 minutes,
1 minute, 15 seconds, and 6 seconds can
be set. (If a temperature change is detected
in the sensing range, the programmed
Cuveo receiver is activated for the set time.
If another temperature change is detected
during the set time, the time starts again.)
c.) The level of light at which the wireless
motion detector responds can be set in four
increments using the slide switch (2) on the
right. Sliding the switch towards "sun icon"
means that the wireless motion detector
will also be activated during the day. Sliding
the switch towards "lunar icon" means that
the wireless motion detector will only be
activated at night.
Teaching a Cuveo receiver
to recognise the wireless
motion detector
d.) Insert two type AA batteries in the battery
compartment making sure the polarity is
correct (plus/+ and minus/-).
e.) Set a Cuveo receiver to learning mode
(see user guide for the respective Cuveo
receiver). This is indicated by a flashing
LED on the receiver.
f.) Before the LED on the receiver stops
flashing, press the "Learning" button (3)
on the wireless motion detector that you
DE
15