WEIBANG WB386HC-M Mode D'emploi page 6

GB
To stop forward motion, release drive control bar.
IMPORTANT: ALWAYS KEEP DRIVE CONTROL
FULLY ENGAGED AGAINST HANDLE WHEN IN USE.
Power propelled:
Stop
start forward
Hand propelled:
Fig.6
Stop start
ENGAGE THE BLADE-CLUTCH (See Fig.7)
only for machines with BBC
NOTE:The blade-brake-clutch should be engag-
ed only when the engine is in maximum throttle
state.
1. For safety, the blade-clutch-lever can not be en-
gaged directly after releasing. Push the lever
forward until it make a 'click' sound, and then
you can engaged the clutch again.
2.Press the blade-clutch-lever close to the handle-
bar completely to engage blade.
3.Release the lever about 2'' away from the hand-
lebar, until the lever make a 'click' sound. And
then re-press the lever and hold it togather with
the handlebar.
4.Release the blade-clutch-lever completely to
dis-engage and stop the blade.
Fig.7
Upper handle
Step 2
Step 1
Blade clutch lever
ADJUSTING THE DRIVE SPEED (FOR SPEED
ADJUSTABLE MODEL)(See Fig.8)
N O T E : T h e s p e e d m a y o n l y be
adjusted when the engine is running
in order to avoid damage!
Fast
(rabbit)
Drive speed
control lever
(tortoise)
07
-The driving speed can be continuously adjusted by us-
ing the adjustment lever mounted on the upper hand.
07
-First press the lever slightly downwards and adjust
to the desired speed. The lever automatically clicks
back into the nearest new position.
-Position rabbit =fast(max.speed)
-Position tortoise =slow (min.speed)
ADJUSTING THE CUTTING HEIGHT (See Fig. 9)
Never adjust the cutting height with the motor still
running.
The mower is adjusted to one cutting height upon
delivery.
All four wheels are adjusted by a single lever except
the model 2in1. The 2in1 mower has two levers to
adjust the front wheel and rear wheel individually.
You can set the cutting height to the desired height
to fit different terrain. Pull the lever out from the catch,
move to the desired position and let it fall back into
the catch.
WARNING: The lawnmower can only be used on
level lawns if the lowest cutting height is being
used.
Fig.9
WHEEL ADJUSTER
LEVER
RAISE WHEELS
FOR LOW CUT
TO ATTACH GRASS CATCHER
(except 2in1 mower)
1.Lift the rear door of the lawn mower, and then
place the locating pins of grass catcher into hooks
on both sides bracket .
2.The grass catcher is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame.
Grass catcher
Fig.8
Locating pin
Bracket hook
Slow
CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to operate
the mower with rear door removed or propped open.
TO EMPTY GRASS CATCHER(except
2in1 mower)
1.Lift up on grass catcher using the frame handle.
2.Remove grass catcher with clippings from under
lawn mower handle.
3.Empty clippings from bag using both frame handle
and bag handle.
NOTE: Do not drag the bag when emptying; it will
cause unnecessary wear.
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as
a mulcher. To convert to bagging or discharging:
REAR BAGGING (except 2in1 mower)
Open rear door and remove mulcher plug. Store
LOWER WHEELS
mulcher plug in a safe place.
FOR HIGH CUT
You can now install the grass catcher.
To convert to mulching or discharging operation,
install mulcher plug into rear discharge opening of
mower.
SIDE DISCHARGING
Mulcher plug must be installed into rear discharge
opening of mower. (for 3in1 mower)
Open discharge guard and install discharge defl-
ector under guard as shown.
Mower is now ready for discharging operation.
To convert to mulching or bagging operation, dis-
charge deflector must be removed and discharge
Fig.10
guard must be closed.
REAR DISCHARGING
Mulcher plug must be removed from rear discharge
opening of mower.
Install 2 triangular brackets on both sides of the
steel rear cover as shown and fasten the screws
Mower is now ready for rear discharging operation.
To convert to mulching or bagging operation, triangular
brackets must be removed.
Fig.11
CAUTION: During operation of emptying
clippings from grass catcher, please wear
protective gloves to prevent environmental
influence on your skin.
CAUTION: Do not run your lawn mower
without rear door closed or approved
grass catcher in place. Never attempt
to operate the lawn mower with the rear
door removed or propped open.
GB
Fig.12
REAR COVER
TRIANGLE BRACKET
08