WEIBANG WB386HC-M Mode D'emploi page 10

GB
1.Engine flywheel brake is on when
control bar is released.
2.Bent engine crankshaft.
Starter rope hard to pull
3.Blade adapter broken.
4.Blade dragging in grass.
1.Cutting height too low.
Grass catcher not filling
2.Lift on blade worn off.
(If required)
3.Catcher not venting air.
1.Grass is too high or wheel height
is too low.
2.Rear of lawn mower housing/blade
Hard to push
dragging in grass.
3.Grass catcher too full.
4.Handle height position not right for you.
1. Belt wear.
Loss of drive
2.Belt off of pulley.
(Power propelled)
3.Dirt in drive pinions.
1.Rear of lawn mower housing of
cutting blade dragging in heavy grass.
2.Cutting too much grass.
3.Dirty air filter.
Loss of power
4.Buildup of grass, leaves, and
trash under mower.
5.Too much oil in engine.
6.Walking speed too fast.
1.Worn, bent or loose blade.
2.Wheel heights uneven.
Poor cut-uneven
3.Buildup of grass, leaves and trash
under mower.
1.Worn, bent or loose blade.
Excessive vibration
2.Bent engine crankshaft.
1)Ensure the engine and blades are stopped and the spark plug disconnected
before performing any maintenance, do not touch the engine muffler after use
at very high temperature.
ATTENTION: Before the mower is stored, make sure the engine cool.
TRANSPORTATION:
Turn off the engine. Make sure the blade are not bent or damaged when you are pus-
hing the mower over obstacles.
15
1.Depress control bar to upper
handle before pulling starter rope.
2.Contact a qualified service center.
3.Replace blade adapter.
4.Move lawn mower to cut grass or
to hard surface.
1.Raise cutting height.
2.Replace blade.
3.Clean grass catcher.
1.Raise cutting height
2.Raise rear of lawn mower housing
one (1) setting higher.
3.Empty grass catcher.
4.Adjust handle height to suit.
1.Check/replace drive belt.
2.Check/reinstall drive belt.
3.Clean drive pinions.
1.Set to Higher Cut position.
2.Set to Higher Cut position.
3.Clean/replace air filter.
4.Clean underside of mower housing.
5.Check oil level.
6.Cut at slower walking speed.
1.Replace blade. Tighten blade bolt.
2.Set all wheels at same height.
3.Clean underside of mower housing.
1.Replace blade. Tighten blade bolt.
2.Contact a qualified service center.
WARRANTY
Proper maintenance of your Weibang equipment is the owner's responsibility. Follow the
instructions in your owners guide for correct lubricants and maintenance schedule. Your
Weibang dealer carries a complete line of quality lubricants and filters for your equipments
engine, transmission, chassis and attachments.
We provide a 2 year warranty from date of purchase: During that time we will replace we
assure a free of charge replacement of any part or parts found to be defective in material
or workmanship or both, after examination by an authorized dealer, or by the service
department of Weibang. We will supply repair services for the machine during a warranty
period limited to 2 years.
A warranty period of 90 days applies to machines used for commercial purposes.
If your lawnmower has malfunctioned within the warranty period, and on presentation of
a properly filled in warranty certificate and the purchase invoice, please contact with
Your local dealer or Y angzhou Weibang Garden Machine, if there is no authorised
maintenance station or dealer in your area. The machine will be repaired expense depended
on warranty certificate and invoice.
All normal wear and tear and/or consumable parts are protected from manufacturer's
defects in material and workmanship for a period of thirty (30) days from the date of purchase.
Damages caused by an inappropriate or faulty operation, by non-observance of the safety
regulations and operating instructions contained in this manual, by unauthorised repairs
or a dismantling of the machine by unauthorised persons, or any other deficiency that
cannot be attributed to faulty workmanship or materials, do not fall under this guarantee.
Such deficiencies, malfunctions or damages are the sole responsibility of the owner, and
eventually necessary repairs are at the owner's expense.
This limited warranty gives you specific legal rights, and which is in addition to any statutory
rights to which you may be entitled and your statutory rights are not affected by this warranty.
If you need additional information concerning this written warranty, or assistance in obtaining
services, please contact:
Yangzhou Weibang Garden Machine Company Limited
Hanjiang Industrial Park
Yangzhou,Jiangsu,P.R.CHINA
Tel:+86-514-87849959,+86-514-87849975 Fax:+86-514-87849938
Email questions and comments to:
Sale@weibang.com
Visit our website:
www.weibang.com
GB
16