Renishaw MI 12 Guide D'installation Et D'utilisation page 13

MI 12 INTERFACE UNIT
PANEL MOUNTING ASSEMBLY
1. Fit brackets A to panel B with
screws, washers and nuts.
(A self clinching stud may be
used in place of screw).
2. Remove protective paper
from gasket C. Attach gasket C
to bezel D.
3. Fit bezel D to panel B
using washers and nuts.
4. Remove base plate G
from interface unit F.
5. Remove footpads H
from base plate G.
6. Insert grommet K into
four baseplate holes.
7. Fit baseplate G within
brackets A.
8. Mount Interface cabinet F
onto baseplate G.
9. Slide cabinet F towards
bezel D to form a good seal.
10. Fit washers and screws L.
F
G
H
A
D
K
A
B
C
1-3
L