Troubleshooting; Accessories - Sennheiser AudioBeam Notice D'emploi

Troubleshooting

GZG 1029
MZT 1019
SEMS 3134
16
Troubleshooting
If the LED operation indicator
problems may have occured:
The distance sensor has triggered
1. Someone has entered the security area of 4 meters in front of or
around AudioBeam and the distance sensor has triggered. After the
person has left this area, AudioBeam automatically turns on again after
30 seconds.
2. You are operating the device in rotating mode and the distance sensor
has triggered because objects or persons are located within the sensor
range of the built-in distance sensor.
o solve the problem, see: „Mounting AudioBeam movably or rotatably"
on page 14.
AudiBeam is defective
Please contact your Sennheiser distributor or the Sennheiser Customer
Service (for address, see last page).

Accessories

The following accessories are available from your Sennheiser distributor:
GZP 10 Mounting plate for wall and ceiling mounting
Swivel joint for attachment to stands or the GZP 10 mounting plate,
1 "
/
includes
4
MZT 14 Mounting bolt for mounting goosenecks and swivel joints with
to table tops
MZT 100 Stable, metal table stand with
Mounting bar for two units with
Floor stand with
lights up red, one of the following
interchangeable thread
3 "
/
thread
8
3 "
/
8
3 "
/
thread
8
internal thread
3 "
/
thread
8